This question confronts every homeowner with a beautiful deck they would like to maintain in perfect conditions. After obliterating the gunk, grime and debris from your driveway or pool area with your spiffy power washer, it is only natural to wonder if you can perform the same in-depth cleaning on other exterior elements of your home.
Decks can succumb to an accumulation of all kinds of dirt, scum and grime and it would seem the easier solution will be to apply pressurized water to the problem and be done with. But, is this actually the best way to deal with the problem? Here is what you need to know about washing your deck with a power washer.
Potential Damage Caused by Power Washing Your Deck
Unlike the concrete on your driveway, or even the vinyl siding on your home, decks are typically made of wood. Wood is not nearly as strong and resistant to water as concrete or vinyl. As a matter of fact, your pressure washer could make an area of small damage or wear far worse. The high pressurized water can split the wooden fibers apart and cause serious damage that will take costly repair work to correct.
It is not just wood that can be damaged by the high pressure of a power washer either. If your deck contains PVC elements, you will find that these can also become affected by the powerful stream of water
Many wooden decks are also made of composite materials, which are basically plasticized wood which can be sturdy building materials. Unfortunately, these are also highly susceptible to the high power of a pressure washer. Even worse, you will have to pay for your damage yourself as this is not a type of damage that is not covered by composite deck warranties
When Is Power Washing My Deck Okay?
On the other hand, there are some situations where a pressure washing for your home’s deck may be just fine. But, you will have to keep the points mentioned above in mind while handling this particularly damaging task.
Here are some important pointers to follow when power washing your wooden deck.
- Get the Right Pressure
You will want to use a lower pressure on your delicate decking materials. If you have a deck made of softer woods, like cedar or pine, you will want to use a lower pressure setting. Softer woods should never be impacted by pressures that exceed 600psi and 500 psi would be a better choice to be safe. You may go as high as 1200 psi on hardwood, but looking for the lowest effective psi setting is highly recommended.
- Use the Right Tip
The best option for preserving your wooden deck is a 45° spread tip. Some seasoned professionals recommend the rotating tip, but this should be used carefully.
- Test a Small Portion
If your deck is older or you just want to play it safe, the best way to begin will be by testing the pressure from your washer on a small portion of the deck that is somewhat inconspicuous. A stair will be a lot easier to replace then one of the actual deck boards in case of serious damage. Begin with a very low setting and work your way upwards pausing between strokes to examine the effects on the wood.
- Get to Work!
If you feel you have found a pressure that will not damage your wood, you can proceed with caution. Remember that different areas of the deck may be more susceptible to damage and work carefully.
- Keep the nozzle 12”to 24” from the wooden deck surface you are cleaning.
- Use a sweeping motion to gently lift the scum and debris. Keeping your arm straight as you do will ensure an even amount of pressure.
- Work in the same direction as the grain of the wood.